Zinga Zinc System
PRODUCTS ZN · 96% pure zinc
Zinga Zinc System
Galvanising in a form that can be applied by brush, roller or spray. It contains a high proportion of pure zinc and gives steel cathodic protection: if the coating is damaged, the zinc sacrifices itself and protection continues.
POSITION IN SYSTEM · Primer / Single coat | ISO 12944 · C4 – CX
TECHNICAL SUMMARY
Product profile.
The values below show the general character of the product family. The product's own technical data sheet (TDS) is authoritative for the exact mixing ratio, curing time and film thickness.
ChemistryOne-component, 96% pure zinc film
Role in the systemPrimer or single-coat system
Typical film thickness60 – 120 µm (usually 2 coats)
Curing typeSolvent evaporation
ApplicationBrush, roller, spray
Key strengthCathodic protection, self-healing, easy repair
WHERE IT IS USED
Key sectors.
APPLICATION NOTES
Points to watch on site.
- Cathodic protection requires direct contact between the zinc film and the steel; the surface must be Sa 2½ or better.
- If an incompatible topcoat is applied, outgassing and blistering may occur; intermediate coat compatibility must be confirmed with the technical team.
- Damaged areas can be sanded and touched up with the same product — system continuity is maintained.
ZINGA ZINC SYSTEM
Request a quote and data sheet →
Technical data sheet and quote
You can request the technical data sheet (TDS), safety data sheet (SDS) and a quote tailored to your project for this product family from our technical team.
